Coating guide · scope before lifespan

Galvanized vs PVC-Coated Welded Mesh

Translate finish names into process, substrate, exposure, inspection and repair questions before specifying welded mesh.

Review a coating requirement Open coating selector

Page responsibility

One page, one decision.

Use this guide for the stated decision, then move the result into the next project step.

This page decides

Which coating-process questions and evidence belong in the enquiry.

This page does not decide

Guaranteed service life or universal corrosion performance from a finish label.

Carry forward

Record substrate, process sequence, environment, inspection evidence and repair method for each offered component.

Direct answer

A finish name is not a coating specification.

Galvanized, PVC-coated, polymer-coated, powder-coated and duplex describe different materials or process combinations. The sequence and substrate matter.

Ask what is coated, when fabrication or welding occurs, which metallic and organic layers are present, how the surface is prepared, what thickness or adhesion checks apply, and how damage is repaired. Do not infer service life from a colour name or transfer a standard for fabricated articles to continuously galvanized wire without checking its scope.

Turn commercial labels into controlled questions.

The offered product may use a different process from another product carrying a similar finish description.

Question	Metallic coating route	Organic or duplex route
What is the substrate?	Wire, welded panel, fabricated frame, post, gate or hardware.	The same substrate question, plus the surface under the organic layer.
When is it applied?	Before welding, after welding, continuous wire processing or batch coating of a fabricated article.	PVC/polymer on wire, powder or paint on a fabricated component, or organic coating over galvanizing.
What must be stated?	Coating process, applicable standard, thickness or mass basis, bare areas and repair method.	Pretreatment, layer sequence, nominal thickness, adhesion or cure checks, colour and repair method.
What can go wrong?	Wrong standard scope, unprotected cuts or welds, handling damage or incompatible repair assumptions.	Poor preparation, adhesion loss, edge damage, layer mismatch or unsupported lifespan claims.
What should be compared?	Exact process and evidence for the offered wire, panel, post, gate and hardware.	Exact layer system and evidence for the offered component and environment.

Define exposure before asking for colour.

No generic website table can convert these inputs into a guaranteed service life.

Environment

Indoor or outdoor, wetting, salt, pollutants, soil contact, abrasion and cleaning chemicals.

Component

Wire, welded fabric, panel, frame, post, gate, hardware or repaired area.

Appearance

Colour, gloss, visual uniformity and acceptable handling marks.

Evidence

Process description, controlled thickness or mass result, adhesion or cure check, repair and maintenance instructions.

ISO 1461 has an explicit exclusion.

The official scope applies to batch hot-dip galvanized coatings on fabricated iron and steel articles; it excludes continuously hot-dip galvanized wire and products such as welded mesh made from that wire.

Do not apply ISO 1461 indiscriminately

Use the exact manufacturing route to select a relevant standard. A panel, post, frame, wire and fixing package may contain components produced by different coating processes.

Review the exact offered finish.

Product names are starting points; the quotation must identify the process and component scope.

product route

PVC-Coated Universal Wire Fence

Review the stated mesh, wire, substrate and polymer-coating route for the offered configuration.

Open →product route

Rust-Resistant Galvanized Wire Mesh

Review the metallic coating route, welding sequence and evidence offered for this product.

Open →planning tool

Coating and material selector

Convert environment, substrate and handling into supplier questions without predicting lifespan.

Open →family hub

Welded mesh family

Return to all published welded mesh products and decision routes.

Open →

Read scope before citing a standard.

These sources explain process and scope; they do not prove a XIEHENG product conforms without product-mapped evidence.

external standard